Compact tractor Kubota L1802 4WD, overhauled and repainted

 

equipment:
• new battery
• new fan belt
• new radiator hoses
• new seat
• new air filter
• new diesel filter
• new oil filter
• new oil
• oil seals are replaced if necessary
• all filters are new
• new or good used tires
• Supplied with foldable roll bar

The following work was made:
• the tractor was completely taken apart
• Engine / transmission have been checked and repaired
• any defective part was replaced
• steering gear overhauled
• radiator checked
• safety switch for clutch

We can prove these works.

Slight paint damage or abrasion might have occurred owing to ocean shipment.

Specification
• Diesel Engine: Kubota D1102 - 3 cylinders with 1115 ccm
• Power: 25,0 PS/18,4 kW at 3000 rpm.
• Bore and stroke: 76 x 82
• clear width front (outside / outside): 1100 mm
• clear width rear (outside / outside):  1200 mm
• Wheelbase center-center: 1500 mm
• ground clearance: 270 mm
• Transmission: mechanical circuit group
• Number of gears: 6 forward and 2 reverse
• Speed: 0,22 - 14,7 km/h
• rotation of the PTO: clockwise
• PTO Speed: 540 - 800 - 1000 - 1250 U/min.
• Diameter of the PTO: 1" 3/8 - 6 G-parted
• agrarian tyres front: 6.00-14
• agrarian tyres rear: 8.3-24
• Dimensions (L x W x H): 250 x 120 x 250 cm
• Weight: 850 kg

Video:

Financing / Leasing for businesses possible - Please contact us!

We guarantee a serious carrying out. You have a full right of return.

Warranty - 1 year. Except on common wear parts, age and running time related wear is not a defect.

Think about of the safety of a standardized EU rollover bar

According to our current state of knowledge - all our competitors sell tractors without EU approved and accepted roll bars - this is a violation of law.

If these dealers offer rollover bars, it"s not a design that conforms to the standard and is not allowed.

In the EU, tractors from 600 kg net weight without equipment must have a tested and by an european test institute accepted roll bar.

We have tested rollover bars with much financial effort.

The manufacture of of a roll bar will cost at least 650.00 euros, so we have to factor with this additional cost.

You"re taking a security risk when you buy a tractor from 600 kg dead weight without a rollover bar!

Delivered with hinged unpainted roll bar.

Additional option:

• Painted roll bar in black for 250.00 euros (this must be communicated to us early enough when placing the order)

Our tractors are equipped with an approved EU rollover bar after the EU: 86 / 298/EWG standard (check the pictures).

Here is one of several test reports and inspection reports!!!