Rear flail mower / flail mower SLM85HL with freewheel
Including 1 bottle of gear oil + all lubrication points are pre-greased!
We have been selling this device since 2005 and always purchase full trucks from our Italian wholesaler, hence our top price for top quality.
The small tractor should have a rear three-point linkage KATI and a clockwise standard PTO shaft with 540 rpm.
Due to its low weight, this flail mower is suitable for smaller tractors. To be on the safe side, use 1st gear and a small group on tall grass so that a small tractor will not be overloaded.
The flail shaft is driven by two V-belts, whereby the clamping device is easy to reach and adjust.
On the front of the mulcher, galvanized pendulum slats prevent stones and other objects from penetrating through - so you are protected from falling rocks.
The device complies with the applicable safety standards and is CE certified.
The mulcher is equipped with a freewheel gear. The PTO is included in the standard scope of delivery.
The flail mower is equipped with hardened steel cup knives, which are in staggered rows around the shaft - cup knives make a clean cut. The knives have a long service life and can easily be re-sharpened with the angle grinder.
Steel hammer mallet
The support bracket and the parking support are included as standard in the scope of delivery. Since the rear roller is equipped with a scraper, it cleans itself over the entire length. The sheet steel housing is 4 mm thick on the outside and the inner part is made of 3 mm sheet steel. The stone guard is located at the front and rear. The cutting height can easily be adjusted in 5 levels.
We guarantee a serious transaction - you have a full right of return.
Technical specifications
• 85 cm working width
• Drive speed 540 rpm
• Gearbox with freewheel
• 15 hardened hammer flail knives
• Stone guard front and rear
• Housing made of 4 mm sheet steel
• Bracket and parking stand as standard
• Weight 118 kg
Advice from practice:
Decisive for the use of an attachment are not only the number of horsepower of a tractor, but also the working speed, cutting height setting, working depth, etc.!
This means that even a smaller tractor can operate a larger attachment at low driving speeds.
We are of course happy to answer any questions you may have.
10 cm offset in the posture
The flail mower can be attached to the tractor offset by 10 cm if the holding triangles are offset accordingly.
Trailing roller can be greased
2 V-belts as drive from the gearbox to the knife shaft
Flail shaft can be fully lubricated
Steplessly adjustable sanding skid, trailing roller adjustable in 5 positions
Bolts (diameter 22 mm) offset inwards
Video:
German operating instructions including parts list are included!
Available directly in our warehouse! All spare parts also in stock!
ATTENTION!
Please shorten the PTO shaft to the appropriate length!
