Rear flail mower SLM105F
with grass collector
The small tractor should have a rear three-point hitch KATI and KATII, a standard PTO clockwise with 540rpm.
At high grass it is safer to go with the 1st gear, then the small tractor is not overloaded.
The mulcher is equipped with freewheel gear. The PTO is included.
The flail mower is equipped with hardened cup knives. The knives have a long service life and can be easily sharpened with an angle grinder.
The steel housing is 4mm thick outside.
The gearbox is fitted as standard with a freewheeling, thus the knife shaft run out when the drive is switched off.
The volume of the cut grass collector is 0.40 m³.
By means of a double acting hydraulic cylinder can be opened and closed the tailgate.
For this purpose, a double-acting control valve must be present on the tractor or be still attached.
If small tractors around 20 hp do not have rear hydraulics, there is a simple solution: remove the hydraulic cylinder on the flail mower and fit a handle to the tailgate. It can then be easily lifted and opened by hand. A chain or wooden stick can be used as a locking device to keep the flap open.
On tractors with front loaders/snow blades or front-mounted implements, you can use the existing control valve, pull a hydraulic hose to the rear and connect it to the lifting cylinder.
The 20 mounted cup knives guarantee a clean cut.
The two front support wheels are not adjustable. But it is a steel roller installed at the rear that is two times height-adjustable.
The real cutting height is infinitely adjustable by adjusting the top link.
In standard scope of delivery, the PTO, the hydraulic cylinder for the rear discharge and hose set are included.
On the hose set a plug-in coupling / bayonet fitting size 3 (20.8 mm) is screwed.
Fill up gear oil!
We guarantee a serious carrying out. You have a full right of return.
Specification
- 105 cm working width
- Drive speed 540 rpm.
- capacity 0,40m³
- gearbox with freewheel
- 20 hardened cup knives
- Stone guard, front and rear
- Housing made of 4 mm steel plate
- for tractors from 15 PS
- PTO, the hydraulic cylinder for the rear discharge and hose set are included
- Weight 315 kg
The rubber lip prevents the escape of stones.
This double V-belt
is permanently tensioned.
Hydraulic container discharge
Container capacity 0.40 m³.
ATTENTION!
Please shorten the PTO shaft to required length.