English Deutsch

Logging trailer, forestry trailer HR500 for small tractors and ATV Quad

Logging trailer, forestry trailer HR500 for small tractors and ATV Quad
Product no.: HR500

899,00 EUR   19 % VAT incl.

Shipping inside Germany: 200,00 EUR *     * Shipping information


Logging trailer, forestry trailer HR500 for small tractors and ATV Quad


The crane shown is not included!

This logging trailer is imported from Sweden. There it is usual to fetch the timber from the forest with Quad / small tractor or jeep.
The frame of the trailer is made of galvanized 4-square tubes. The side supports are made of this material too.
It is possible with little effort to increase the side arms (red 4-Square tubes), by putting a longer 4-Square-tube into the holder.

The payload should be no more than 750 kg if it is used on the road because the trailer is unbraked.

For use in non-road traffic, the payload is up to max. 2 tons.

Pay attention to safety on the weight ratio between tractor and trailer or when used on inclines. Only the driver is responsible.

It has a length of 2.40 m and is extendible to 3.60 m. Please check the screws and tighten if necessary.

The four large ATV tires are movably mounted on the two axes, so they can adapt to any ground unevenness. The swing axle is greasable.

The trailer has no approval, TUV or similar.

An approval of the DEKRA costs 390,00 Euros - as well as a retrofitting of the trailer on street legal costs 300,00 € (such as light strip, stop light, turn signals/dirction indicator, etc.).

Here you can see the road traffic regulations conversion respectively 2 additional stakes mounted to transport short timber.

Then the top speed is limited to 25 km / h.

The tire size is 22x12-8 with an outer diameter of 55 cm and a tire width of 25 cm.

We sell these trailers since 2006 in Germany.

We guarantee a serious carrying out. You have a full right of return.

Specification

  • Frame and side holder/bracket 4--Square pipes
  • max. Payload on the road - because unbraked: 750 kg
  • max. Payload when using non-road traffic - without authorization: 2 tons
  • Net weight: 170 kg without crane
  • Tires: 22x12-8 (with a diameter of 55 cm and a tire width of 25 cm)
  • Dimensions (LxWxH): 2400 (extended 3600) x 1200 x 1800 mm



completely pushed together

completely telescoped



Central pivot greasable

26cm ground clearance of the axis
40cm ground clearance of the frame

front 100cm displaceable
rear 70cm displaceable
60cm wheel diameter

Currently this logging trailer is supplied with this tire profile.

Here the skip / cargo box is mounted.

Additional stanchions are available for 89,00 Euro surcharge.

With this trailer you have a useful helper for timber transport.

Winch 12V for 225.00 Euro extra cost.

  • Line pull 1360kg
  • rope length 13m

Remote control for 80.00 Euro extra cost.

Hand Winch for 60,00 Euro extra cost.

Skip/Cargobox for 350,00 Euro extra cost.

 


⇒ Typing errors, misapprehensions and changes excepted.


top top

This product is compatible with:

Hydraulic power unit with 7.0 PS petrol motor hydraulic pump external drive

Hydraulic power unit with 7.0 PS petrol motor hydraulic pump external drive

499,00 EUR (19 % VAT incl. * Shipping information)
Support wheel for trailers HR500, Tandem500T and 1003Z

Support wheel for trailers HR500, Tandem500T and 1003Z

75,00 EUR (19 % VAT incl. * Shipping information)

Parse Time: 0.179s