English Deutsch

Belt tedder M18 1,45 m for two wheel tractors

Belt tedder M18 1,45 m for two wheel tractors
Product no.: M18

1.450,00 EUR   19 % VAT incl.

Shipping inside Germany: 110,00 EUR *     * Shipping information

Shipping time: immediately available from stock, since we have several stores in the vicinity, we ask for tel. Pre-registration for pick-up

Belt tedder M18 1,45 m for two wheel tractors

This band tedder has a working width of 145 cm.

By pressing the handlebar light steering is possible.

It is made for windrowing and swathing.

On the side a swath board is attached. It just needs to be pulled out to make a windrow - so you can turn hay without sweating.

We guarantee a serious carrying out. You have a full right of return.


  • 145 cm working width
  • weight 85 kg
  • 165 cm overall width
  • with  swath board

Immediately available with adapter for walking tractors KM5 and KM8.

It is possible to install this implement via a transmission adapter in nearly all two wheel tractors (for example: Agria, Barbieri, Fort, Goldoni, Bertolini, Nibbi, BCS, Ferrari). Please ask for the price of the compatible adapter to your two wheel tractor.

In Italy there are about 50 walk behind tractors manufacturers. Each manufacturer has its own port, so we will need the information on the nameplate of the two wheel tractor (motor data are uninteresting).

Only then is it possible to get the right adapter. A majority of common adapters we have in stock. For direct orders in Italy, we need an average delivery time of approximately 3 weeks.

Furthermore, we need pictures and measurements from your two wheel tractor connector as follows:

walk behind tractor:

Diameter of the pipe connection or Quickfit connection on walk behind tractor

Sliding sleeve on walk behind tractor:

Number of teeth
(1) Inner diameter of the toothing
(2) outer diameter of the toothing

Screw connector of two wheel tractor:

(1) center to center of the bolt diameter
(2) Inside diameter

Number of teeth
(1) Inner Diameter
(2) outer diameter


(1) Outside diameter of the implement
(2) Distance from center of hole to end of pipe
(3) length of the toothed shaft

Number of teeth
(1) Inner Diameter
(2) outer diameter

Screw connection of the implement:

(1) Inner diameter of the plug sleeve
(2) outer diameter of the plug sleeve

Diameter of the center


⇒ Typing errors, misapprehensions and changes excepted.

top top
Parse Time: 0.676s