Mulcher-mower Falc8 for two wheel tractors with 80 cm working width

Product no.: Falc8

1.590,00 EUR   19 % VAT incl. Shipping inside Germany: 85,00 EUR *     * Shipping information Shipping time: immediately available from stock, since we have several stores in the vicinity, we ask for tel. Pre-registration for pick-up

 

Falc 8 - working width of 80 cm with a weight of 80kg

 

No matter how high the grass is, with this mulcher there is no stopping. The power is transmitted via gear wheels (in oil bath).

This mower can be used with an engine power of 10PS. 3 movable blades are mounted on each blade disc. 6 blades to 80 cm cutting width will shred the grass short and small. The cutting height can be infinitely adjusted by means of an adjusting screw.

As wear part only the blade can be seen.

The manufacturer Zanon.it supplies all Italian two wheel tractor manufacturers with its products.

Technical specifications:

• Weight: 110 kg

 

 

Immediately available with adapter for walking tractors KM5 and KM8.

It is possible to install this implement via a transmission adapter in nearly all two wheel tractors (for example: Agria, Barbieri, Fort, Goldoni, Bertolini, Nibbi, BCS, Ferrari). Please ask for the price of the compatible adapter to your two wheel tractor.

In Italy there are about 50 walk behind tractors manufacturers. Each manufacturer has its own port, so we will need the information on the nameplate of the two wheel tractor (motor data are uninteresting).

Only then is it possible to get the right adapter. A majority of common adapters we have in stock. For direct orders in Italy, we need an average delivery time of approximately 3 weeks.

Furthermore, we need pictures and measurements from your two wheel tractor connector as follows:

walk behind tractor:

Diameter of the pipe connection or Quickfit connection on walk behind tractor

Sliding sleeve on walk behind tractor:

Number of teeth
(1) Inner diameter of the toothing
(2) outer diameter of the toothing

Screw connector of two wheel tractor:

(1) center to center of the bolt diameter
(2) Inside diameter

Number of teeth
(1) Inner Diameter
(2) outer diameter

Implement:

(1) Outside diameter of the implement
(2) Distance from center of hole to end of pipe
(3) length of the toothed shaft

Number of teeth
(1) Inner Diameter
(2) outer diameter

Screw connection of the implement:

(1) Inner diameter of the plug sleeve
(2) outer diameter of the plug sleeve

Diameter of the center

⇒ Typing errors, misapprehensions and changes excepted.

top